Face extend

[Henrik_Lo]

HI

Is it possible to extend the curved face of the solid, straight up to the new not curved face.

It need to be a solid 

Regards

Henrik

[JDMather]

Are you aware the corners will cross over before you get to that surface?

Do you have the original geometry from which the Base was created?

[SBix26]

Delete the existing 3D sketch (not sure what its purpose is).  Create a new sketch on the flat surface, project the perimeter of the curved surface, then extrude to next.  It makes a rather odd-looking part, because the lower section has a significant draft, the upper part doesn't.

[Henrik_Lo · Accepted solution]

HI Seem fine to me, just as I need, thanks, the part is for a Mold part.

Regards Henrik