Inventor General Discussion

Reply
Valued Contributor hlo
Valued Contributor
hlo
Posts: 91
Registered: ‎10-08-2006
Message 1 of 4 (171 Views)
Accepted Solution

Face extend

171 Views, 3 Replies
08-21-2012 04:11 AM

HI

 

Is it possible to extend the curved face of the solid, straight up to the new not curved face.

It need to be a solid 

 

Regards

Henrik

HI Seem fine to me, just as I need, thanks, the part is for a Mold part.

 

 

Regards Henrik

*Expert Elite*
JDMather
Posts: 27,437
Registered: ‎04-20-2006
Message 2 of 4 (161 Views)

Re: Face extend

08-21-2012 04:52 AM in reply to: hlo

Are you aware the corners will cross over before you get to that surface?

Do you have the original geometry from which the Base was created?

 

corners.PNG

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Pro
sbixler
Posts: 1,924
Registered: ‎09-15-2003
Message 3 of 4 (159 Views)

Re: Face extend

08-21-2012 04:58 AM in reply to: hlo

Delete the existing 3D sketch (not sure what its purpose is).  Create a new sketch on the flat surface, project the perimeter of the curved surface, then extrude to next.  It makes a rather odd-looking part, because the lower section has a significant draft, the upper part doesn't.

Valued Contributor hlo
Valued Contributor
hlo
Posts: 91
Registered: ‎10-08-2006
Message 4 of 4 (151 Views)

Re: Face extend

08-21-2012 07:16 AM in reply to: sbixler

HI Seem fine to me, just as I need, thanks, the part is for a Mold part.

 

 

Regards Henrik

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.