Inventor General Discussion

Inventor General Discussion

Reply
Contributor
tvernonbaker
Posts: 13
Registered: ‎01-08-2013
Message 1 of 4 (1,355 Views)
Accepted Solution

Extrude Cut from 3D Sketch (or something like it)

1355 Views, 3 Replies
01-09-2013 09:54 AM

I know my subject is somewhat mis-named, because I gather that you cannot really extrude from a 3D sketch, however I am looking for a way to accomplish what extruding a cut from a 3D sketch would accomplish.

 

The problem is this: I have a simple 2D sketch that I've projected onto a curved surface (imagine a square projected onto the outside of a hollow cylinder). Now that I have a 3D sketch on the surface of the cylinder, I want to use that sketch as a "cookie cutter" through one wall of the cylinder.

 

If I were to simply extrude the cut from the 2D sketch, the "cookie" is wider at the edges than at the center. I want the cut to be perpendicular to the projected 3D sketch at all points. 

 

I've attached a simple example that illustrates my problem.

 

Can anyone help? Thank you in advance!

Split and Thicken-Cut

Emboss might also be a solution.

*Expert Elite*
JDMather
Posts: 26,893
Registered: ‎04-20-2006
Message 2 of 4 (1,352 Views)

Re: Extrude Cut from 3D Sketch (or something like it)

01-09-2013 10:02 AM in reply to: tvernonbaker

Split and Thicken-Cut

Emboss might also be a solution.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Contributor
tvernonbaker
Posts: 13
Registered: ‎01-08-2013
Message 3 of 4 (1,346 Views)

Re: Extrude Cut from 3D Sketch (or something like it)

01-09-2013 10:10 AM in reply to: JDMather

Thanks!

New Member
Desolationism
Posts: 1
Registered: ‎12-03-2013
Message 4 of 4 (753 Views)

Re: Extrude Cut from 3D Sketch (or something like it)

12-03-2013 12:57 PM in reply to: JDMather

I know this is old, but good god, you just saved me so much time.  We do a lot of odd shape and transition HVAC style ducting, this saves my life!

 

Thank you, thank you, thank you!

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.