Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎11-11-2012
Message 1 of 2 (345 Views)

Extrude a horizontal small cylinder across a vertical big cylinder

345 Views, 1 Replies
11-11-2012 09:51 AM

Dear guys,

In inventor 2013 I want to extrude  a horizontal circle on surface of a bigger vertical hollow cylinder. but waht i did it enters into cylinder, and i only want to extrude it on external surface. I would be greatfull for anyone who can help me.the file is attached.

*Expert Elite*
Posts: 26,848
Registered: ‎04-20-2006
Message 2 of 2 (341 Views)

Re: Extrude a horizontal small cylinder across a vertical big cylinder

11-11-2012 11:13 AM in reply to: tally11

In general you should add holes near the end of a design.

Model the part similar to the way ti would be manufactured.

You could extrude and cut away again, but I recommend simply starting over and do the part correctly from the beginning.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.