Inventor General Discussion

Inventor General Discussion

Reply
New Member
tally11
Posts: 1
Registered: ‎11-11-2012
Message 1 of 2 (373 Views)

Extrude a horizontal small cylinder across a vertical big cylinder

373 Views, 1 Replies
11-11-2012 09:51 AM

Dear guys,

In inventor 2013 I want to extrude  a horizontal circle on surface of a bigger vertical hollow cylinder. but waht i did it enters into cylinder, and i only want to extrude it on external surface. I would be greatfull for anyone who can help me.the file is attached.

*Expert Elite*
JDMather
Posts: 28,254
Registered: ‎04-20-2006
Message 2 of 2 (369 Views)

Re: Extrude a horizontal small cylinder across a vertical big cylinder

11-11-2012 11:13 AM in reply to: tally11

In general you should add holes near the end of a design.

Model the part similar to the way ti would be manufactured.

You could extrude and cut away again, but I recommend simply starting over and do the part correctly from the beginning.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.