Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
Billduck
Posts: 55
Registered: ‎01-26-2009
Message 1 of 2 (227 Views)

Extended part cost in the BOM

227 Views, 1 Replies
11-09-2012 10:44 AM

   The BOM tabulates the item "quantity", and  "cost center", the latter recorded with the part thru iProperties.

Is there a way to have Inventor multiply these together for an extended cost. I know I could manually enter the # but that will not change automatically, when the part count changes.

*Expert Elite*
Mark_Wigan
Posts: 458
Registered: ‎03-07-2006
Message 2 of 2 (189 Views)

Re: Extended part cost in the BOM

11-12-2012 05:12 AM in reply to: Billduck

Wthout programming i think you will have to just do it in excel after you export your BOM. 

 

You will likely have to do that bom as parts only, all levels.

best regards,
- Mark

(Kudo or Tag if Solved - it may help others)

PDSU 2015 Windows 8.1, 64bit.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.