Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
gsmith9810
Posts: 115
Registered: ‎12-28-2012
Message 1 of 3 (148 Views)
Accepted Solution

Exact View Point and Perspective

148 Views, 2 Replies
01-31-2014 02:47 PM

I know INV does this and I suppose I could dig to find it...

 

...but asking here is so much easier than digging.

 

There are times when I would like to define the viewing poing of the model exactly...

 

...say 48 inches off the floor and 120 inches away from the front face of an assembly.

 

Further, I'd like to define the viewing perspective as a function of the type of camera lens being used, say: 55mm or 135mm.

 

Can anyone point to those settings?

 

Thanks!

-------------------------------------------------------
Gary Smith
Inventor Product Design Suite 2013sp2
Windows 7sp1 64-bit
nVidia Quadro 2000
Distinguished Mentor
rdyson
Posts: 896
Registered: ‎04-11-2005
Message 2 of 3 (117 Views)

Re: Exact View Point and Perspective

02-01-2014 06:45 AM in reply to: gsmith9810

You can probably get close enough in Studio. You may need to create a dummy part to use to position the camera where you want.

 

Capture.JPG

Distinguished Contributor
gsmith9810
Posts: 115
Registered: ‎12-28-2012
Message 3 of 3 (97 Views)

Re: Exact View Point and Perspective

02-03-2014 06:37 AM in reply to: rdyson
I suspect that is what I'm remembering...

...thanks!
-------------------------------------------------------
Gary Smith
Inventor Product Design Suite 2013sp2
Windows 7sp1 64-bit
nVidia Quadro 2000
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.