Inventor General Discussion

Reply
Valued Contributor
simon_toaldo
Posts: 75
Registered: ‎04-19-2012
Message 1 of 3 (54 Views)
Accepted Solution

error

54 Views, 2 Replies
12-14-2012 03:08 AM

How do i fix these error with the Hole and hole pattern please?

 

Thank you,

 

Simon

You need to redefine your sketch origin. In the browser, right click on sketch4 and select "Edit Coordinate System". A symbol will appear in the graphics window, pick the blue ball at the center. Then in the browser, expand the Origin folder and select "Center Point". Then select "OK". That will set your sketch origin to the origin of the part.

Valued Mentor
japike
Posts: 322
Registered: ‎02-06-2004
Message 2 of 3 (52 Views)

Re: error

12-14-2012 03:59 AM in reply to: simon_toaldo

You need to redefine your sketch origin. In the browser, right click on sketch4 and select "Edit Coordinate System". A symbol will appear in the graphics window, pick the blue ball at the center. Then in the browser, expand the Origin folder and select "Center Point". Then select "OK". That will set your sketch origin to the origin of the part.

Peace,
Jeff
Inventor 2013
Valued Contributor
simon_toaldo
Posts: 75
Registered: ‎04-19-2012
Message 3 of 3 (46 Views)

Re: error

12-14-2012 04:06 AM in reply to: japike

Thanks Jeff

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.