Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
67 Posts
2 Kudos
Registered: ‎12-06-2012
Post 1 of 5

Error when try to Athor a I part **** a custom member to the Content centre

150 Views, 4 Replies
12-20-2012 11:16 PM

Hi All,

 

we are getting an Error when try to Athor an I part **** a custom member to the Content centre. Im the administrator,  when I use my coleuges machine the Authoring go through, security settings, pc setting everything is the same, I use the local host content centre,

 

any Idea why this error appears

 

see attached

*Expert Elite*
3,509 Posts
864 Kudos
Registered: ‎04-06-2010
Post 2 of 5

Re: Error when try to Athor a I part **** a custom member to the Content centre

12-21-2012 04:59 AM in reply to: jacoj

Are you using Vault?

ChrisB / Twitter

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cadtipstricks.wordpress.com//


   

Valued Contributor
67 Posts
2 Kudos
Registered: ‎12-06-2012
Post 3 of 5

Re: Error when try to Athor a I part **** a custom member to the Content centre

01-01-2013 08:59 PM in reply to: cbenner

Hi,

 

sure we do you uses Vault,

but if I go onto another machine, with exactly the same settings, and exactly the same rights, im allowed to do this,

even If I try to use the local host content centre on the C drive.

 

kind regards.

*Expert Elite*
3,509 Posts
864 Kudos
Registered: ‎04-06-2010
Post 4 of 5

Re: Error when try to Athor a I part **** a custom member to the Content centre

01-02-2013 04:09 AM in reply to: jacoj

Can you make certain that FG is loaded on the machine where it does not work?  Go to Tools\Add Ins and look to see if Frame Generator is loaded in the list as in the picture here:

 

frame.JPG

ChrisB / Twitter

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cadtipstricks.wordpress.com//


   

Valued Contributor
67 Posts
2 Kudos
Registered: ‎12-06-2012
Post 5 of 5

Re: Error when try to Athor a I part **** a custom member to the Content centre

01-02-2013 04:20 AM in reply to: jacoj

hi,

 

yes, it has been loaded, has checked this before as well, and its was loaded.

the right rights has been activated in the projects, and are logged in as administrator

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!