Inventor General Discussion

Inventor General Discussion

Reply
New Member
ranchp
Posts: 1
Registered: ‎11-20-2012
Message 1 of 1 (140 Views)

Error loading segment Default in database....

140 Views, 0 Replies
11-20-2012 02:17 PM

Hi,

 

I'm using Inventor 2009 Suite with service pack 2, and I have a corrupted assy which behaves perfectly as a subassy to a higher level assy, but will not allow me to open it to edit it. The 3 copies in oldversions will not open either (they're all dated within about a half hour of each other) so that option is not available.

 

I saw a similar thread with the same subject from back in 2008, but apparently the problem was persued offline as there are no postings resolving the issue.

 

Any ideas for debugging this problem? This particular assy is used on multiple upper level assys and I hate to think of rebuilding it and replacing it if I can help it (not to mention the ipn and idw associated with it)

 

Thanks in advance

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.