Inventor General Discussion

Inventor General Discussion

Reply
Member
rsoni1997
Posts: 3
Registered: ‎12-01-2012
Message 1 of 5 (607 Views)

Error 1920

607 Views, 4 Replies
12-14-2012 03:43 PM

"Error 1920". "The Service failed to start. Verify that you have sufficient privileges to start system services." This always comes up everytime I try downloading Inventor 2013. I am also a student,so I get it for free. I have tried running it as an administrator, but it still doesn't work. I have already downloaded all the needed drivers. I am attaching a screen shot. Please help me with this. Thank you. 

*Pro
sbixler
Posts: 1,968
Registered: ‎09-15-2003
Message 2 of 5 (575 Views)

Re: Error 1920

12-16-2012 05:32 PM in reply to: rsoni1997

Let's be clear on terminology to start with-- it looks from your screenshot that you are installing Inventor 2013, not downloading it, correct?  Downloading is how the installer gets to your computer from Autodesk's website, installing is getting the software configured and ready to run on your computer.

 

When you run the installer have you set your UAC to minimum and stopped your antivirus utility?  Do you have administrator privileges?

Member
rsoni1997
Posts: 3
Registered: ‎12-01-2012
Message 3 of 5 (547 Views)

Re: Error 1920

12-17-2012 02:07 PM in reply to: sbixler

It doesn't work

Member
rsoni1997
Posts: 3
Registered: ‎12-01-2012
Message 4 of 5 (543 Views)

Re: Error 1920

12-17-2012 02:14 PM in reply to: rsoni1997

Is there a way an expert could remotely look at the problem and fix it? 

The problem happens when I install the Inventor 2013. The problem only shows up when it's installing inventor.

*Expert Elite*
Curtis_Waguespack
Posts: 3,000
Registered: ‎03-08-2006
Message 5 of 5 (525 Views)

Re: Error 1920

12-17-2012 03:16 PM in reply to: rsoni1997

Hi rsoni1997,

You might ask this question over here:

http://forums.autodesk.com/t5/Installation-Licensing/bd-p/24

 

Autodesk staff  actively monitor the Installation & Licensing forum, working with the existing community to answer your installation and licensing questions.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.