Inventor General Discussion

Inventor General Discussion

Reply
New Member
clifflighthouse
Posts: 1
Registered: ‎12-04-2002
Message 1 of 2 (185 Views)

embossing a sheet metal part

185 Views, 1 Replies
12-04-2002 04:45 PM
I am trying to make a custom emboss part in sheet metal, I can see that that there are emboss part in the Ifeatures but how do you make one ?. I am using inventor 5
*Keller, Kent
Message 2 of 2 (185 Views)

Re: embossing a sheet metal part

12-05-2002 12:14 AM in reply to: clifflighthouse
Click on the point A icon in Inventor, then click on Articles, and find the iFeatures and
punches article

I would guess that both Drew and Sean have some info also.

www.mymcad.com
www.sdotson.com


--
Kent
Member of the Autodesk Discussion Forum Moderator Program


"clifflighthouse" wrote in message
news:f129b2e.-1@WebX.maYIadrTaRb...
> I am trying to make a custom emboss part in sheet metal, I can see that that there are
emboss part in the Ifeatures but how do you make one ?. I am using inventor 5
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.