Inventor General Discussion

Reply
New Member
np24
Posts: 1
Registered: ‎11-11-2002
Message 1 of 2 (53 Views)

Elbow

53 Views, 1 Replies
11-11-2002 01:07 PM
I have been trying to figure out how to create an elbow with little luck. I am looking to make a 1/2" copper elbow. I can create the ends but I can't get the sweep. Any help would be appreciated. thanks.
*Keller, Kent
Message 2 of 2 (53 Views)

Re: Elbow

11-11-2002 02:15 PM in reply to: np24
You might take a look at how some of the parts on this page were built

http://www.cbliss.com/inventor/Parts/Plumbing/plumbing.htm

--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program

http://www.MyMcad.com/KWiK/Mcad.htm

"np24" wrote in message
news:f12236c.-1@WebX.maYIadrTaRb...
> I have been trying to figure out how to create an elbow with little luck.
I am looking to make a 1/2" copper elbow. I can create the ends but I can't
get the sweep. Any help would be appreciated. thanks.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.