Inventor General Discussion

Reply
New Member
np24
Posts: 1
Registered: ‎11-11-2002
Message 1 of 2 (59 Views)

Elbow

59 Views, 1 Replies
11-11-2002 01:07 PM
I have been trying to figure out how to create an elbow with little luck. I am looking to make a 1/2" copper elbow. I can create the ends but I can't get the sweep. Any help would be appreciated. thanks.
*Keller, Kent
Message 2 of 2 (59 Views)

Re: Elbow

11-11-2002 02:15 PM in reply to: np24
You might take a look at how some of the parts on this page were built

http://www.cbliss.com/inventor/Parts/Plumbing/plumbing.htm

--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program

http://www.MyMcad.com/KWiK/Mcad.htm

"np24" wrote in message
news:f12236c.-1@WebX.maYIadrTaRb...
> I have been trying to figure out how to create an elbow with little luck.
I am looking to make a 1/2" copper elbow. I can create the ends but I can't
get the sweep. Any help would be appreciated. thanks.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!