Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
KevinPinks7697
Posts: 1,045
Registered: ‎09-10-2002
Message 1 of 7 (115 Views)

Editing hatch region

115 Views, 6 Replies
12-12-2005 12:01 PM
I have attached a hatch to a sketch on a layout view, but now I would like to edit the hatch or remove it and start again. How do I do this?
Thx
Kev
Active Contributor
wim 3dvorm
Posts: 45
Registered: ‎05-06-2005
Message 2 of 7 (115 Views)

Re: Editing hatch region

12-12-2005 05:19 PM in reply to: KevinPinks7697
I don't know if this is what you looking for and also a little bit late, select the hatchbutton and then the hatch, so you can change or disable it.
Distinguished Contributor
KevinPinks7697
Posts: 1,045
Registered: ‎09-10-2002
Message 3 of 7 (115 Views)

Re: Editing hatch region

12-13-2005 05:44 AM in reply to: KevinPinks7697
I can't select the Hatch button, the "Fill/Hatch Sketch Region" button is greyed out when I am in the sketch
Active Contributor
wim 3dvorm
Posts: 45
Registered: ‎05-06-2005
Message 4 of 7 (115 Views)

Re: Editing hatch region

12-13-2005 06:07 AM in reply to: KevinPinks7697
Are you sure you are in the right sketch, also in the sketch mode you can select other sketches for moving.
Distinguished Contributor
KevinPinks7697
Posts: 1,045
Registered: ‎09-10-2002
Message 5 of 7 (115 Views)

Re: Editing hatch region

12-13-2005 08:18 AM in reply to: KevinPinks7697
All I am trying to do is edit the scale of the hatch in the hole?
Thx
Kev
Active Contributor
wim 3dvorm
Posts: 45
Registered: ‎05-06-2005
Message 6 of 7 (115 Views)

Re: Editing hatch region

12-13-2005 08:58 AM in reply to: KevinPinks7697
I see the green sketch line, but can't see projected geometry, did you use projected geometry?
I've tried do the same, see attached jpg.
If you sketch one line in a sketch you can use the hatch button, so it is strange that your button is greyed out.
Do you enter the sketch by double clicking on the sketch line?
Distinguished Contributor
KevinPinks7697
Posts: 1,045
Registered: ‎09-10-2002
Message 7 of 7 (115 Views)

Re: Editing hatch region

12-13-2005 09:59 AM in reply to: KevinPinks7697
I got it to work now, thanks
Kev
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.