Inventor General Discussion

Inventor General Discussion

Reply
Contributor
jacornej
Posts: 18
Registered: ‎09-12-2012
Message 1 of 3 (170 Views)

Editing a Content Center part

170 Views, 2 Replies
02-04-2013 12:36 PM

I have a part published in my content center that was not authored with Tube & Pipe connections. I was wondering if there was a way to edit that part and re-publish it, or would I have to delete it from my Content Center.

 

I'm running INV 2011

Valued Contributor
jacoj
Posts: 67
Registered: ‎12-06-2012
Message 2 of 3 (107 Views)

Re: Editing a Content Center part

05-15-2013 09:35 PM in reply to: jacornej

Hi,

 

I Also want to edit content centre part, did you manage to do this?

jaco

*Expert Elite*
cbenner
Posts: 3,421
Registered: ‎04-06-2010
Message 3 of 3 (98 Views)

Re: Editing a Content Center part

05-16-2013 04:23 AM in reply to: jacoj

Try this:

 

Open From Content Center, as custom, and save it in a working folder somewhere.  Open the part or ipart (whatever it is), perform the authoring steps for tube & pipe and save. 

 

Edit Content Center, right click on the part and select Replace Family Template, then point it to the part you just authored.  This SHOULD do the trick.  I've never tried it on a part that was not authored in an attempt to add the T&P authoring.

 

This will work for the original post,... jacoj, were you trying to do the same thing?

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cadtipstricks.wordpress.com//


   

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.