Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
ozitag
Posts: 288
Registered: ‎05-09-2008
Message 1 of 3 (123 Views)
Accepted Solution

Editing a content center library

123 Views, 2 Replies
02-15-2012 05:03 AM

Hi,

I'm trying to fix up the iproperties of a content centre item. However the part has been used before and saved in Vault. I have edited the library and then when I tried to use a part from the library, the part is just pulled from Vault, hence not having the edits on it. I tried a part that hasn't been used before and it works ok. How can I force it to rebuild from the content center so I can save over the copy in Vault?

Thank,

Ozitag

IV 2010
*Expert Elite*
cbenner
Posts: 3,215
Registered: ‎04-06-2010
Message 2 of 3 (121 Views)

Re: Editing a content center library

02-15-2012 05:06 AM in reply to: ozitag

Have you done a refresh on the part in an assembly where it has been placed?  If you do that, it should prompt you to check the part out... do the refresh, and then when you check it back in it should be the new version.

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cbennertipstricks.blogspot.com/


   

Distinguished Contributor
ozitag
Posts: 288
Registered: ‎05-09-2008
Message 3 of 3 (102 Views)

Re: Editing a content center library

02-15-2012 06:35 AM in reply to: cbenner

Yep, thanks, this worked. I also found if I checked it out without getting the latest version, ie have no version on my PC, then it would also update.

Regards,

Ozitag

IV 2010
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.