Hello, we are using holes in our constructions that consists of 3 holes on top of eachother (with difrent Ø values for seating depth) each hole is also chamfered.
looksl ike this:
Is there a way to make theese holes in one go? (using a sketch with points marking the holes), right now im using the share sketch feature and putting down 3difrent holes on top of eachoter, and a chamfer, so would be nice if they could be saved as a premade hole.
saves time and having to memorise the difrent depths for the difrent dimensions.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!