Inventor General Discussion

Inventor General Discussion

Reply
Contributor
jeroenwm
Posts: 21
Registered: ‎07-13-2011
Message 1 of 3 (248 Views)

dynamic stress simulation

248 Views, 2 Replies
10-14-2012 08:13 AM

is their a possibility to applay stress like dynamic i have a shaft that has a pully on it , its conectet on an old way 

not with a tight fit so it shrinks on it but it works wit a small cut in the shaft where its bolted with just a tiny metal plate.

 

at this place will be a stress concentration and i wanne see how the noth effect is when their is a dynamic load on it cause if i put a static load on it i know the shaft can handel it but i real life it has broken couple of times so this is what i want to investigate shaft.png

i hope you understand my question and help me  kind regards

*Expert Elite*
JDMather
Posts: 28,228
Registered: ‎04-20-2006
Message 2 of 3 (240 Views)

Re: dynamic stress simulation

10-14-2012 10:30 AM in reply to: jeroenwm

Can you test the assembly in the Dynamic Simulation environment and output time-steps to FEA for Motion Loads Analysis?

 

I don't see any twisting forces on your shaft - how is the shaft used in an assembly?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Contributor
jeroenwm
Posts: 21
Registered: ‎07-13-2011
Message 3 of 3 (229 Views)

Re: dynamic stress simulation

10-14-2012 12:31 PM in reply to: JDMather

on the shaft is a pully that guides a  chain but somtimes the  chain blocks and so the motor + reductor builds up tention until it releases . i asume that the worst place is when the pully is in that direction when the pulling force is in a perpendicular direction with the flat surface  so the shaft is getting "pulled open" if you get what i mean . i think multiple times of this force will tear the shaft at the red line in the picture. this is how i wanne simulated it 

 

can i do this with inventor or do i need the multi physics for it ? 

 

in other words their isnt going to be a twisting force cause the chain guides trough it only the friction between the chain and pully is going to make it turn around but this forces are neglecteble 

 

Kind regards

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.