Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
android_mike
Posts: 116
Registered: ‎11-30-2010
Message 1 of 2 (142 Views)

.dwg suffix inch mark spacing

142 Views, 1 Replies
11-14-2011 04:11 PM

Hello

 

im using IV 2011 RS, the spacing of my suffix is like double spaced it looks like 15  "  and i want them to look like 15"

Employee
jozef.dubaj
Posts: 41
Registered: ‎11-22-2011
Message 2 of 2 (93 Views)

Re: .dwg suffix inch mark spacing

11-23-2011 03:41 AM in reply to: android_mike

Hi Mike,

 

from the screen shot it is obvious there are several dimension styles used. Inch mark spacing is caused by overal width of booth lines (main and alternate units). In the cases where the inch mark is not that far and should be (following the rule) I suspect that dimension text has been overwritten manually to include the inch mark.

Please could you check it?

 

 

Regards,

Jozef

(Autodesk)

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.