Hi All,
I cannot figure out how to dual dimension a bend like so:
DIRECTION DEGREES RIMPERIAL [RMETRIC]
eg. DOWN 90 R1/2"[13] preferred
or DOWN 90 R1/2"[R13] okay
There should be a degree symbol after the 90 in my examples but I can't figure out how to type it here.
I can get DOWN 90 R1/2"[DOWN 90 R13] but it's too long.
Any help would be much appreciated.
Thank you.
I did some playing I don't think you can as of now. But you are correct the words should not be included..
If I find a way I will post..
But to get this 90° hold down the Alt key and type 0176 this will give you degree symbol °