Inventor General Discussion

Inventor General Discussion

Reply
New Member
wered6
Posts: 1
Registered: ‎05-28-2010
Message 1 of 2 (121 Views)

Drilling a hole at an angle

121 Views, 1 Replies
05-28-2010 10:11 PM
Ok, i had an idea i wanted to design and i took a class that used this program a few years back so i whent and bought a copy and am trying to design this thing but i cant figure out how to put a hole in a flat surface at an angle. how do i do this?
*Level42
Message 2 of 2 (121 Views)

Re: Drilling a hole at an angle

05-28-2010 10:44 PM in reply to: wered6
wrote in message news:6399911@discussion.autodesk.com...
Ok, i had an idea i wanted to design and i took a class that used this
program a few years back so i whent and bought a copy and am trying to
design this thing but i cant figure out how to put a hole in a flat surface
at an angle. how do i do this?

create another plane relative to that surface.....read the Help files.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.