Inventor General Discussion

Reply
Distinguished Contributor
pquenzi
Posts: 203
Registered: ‎12-12-2003
Message 1 of 2 (52 Views)

Disappearing dimensions

52 Views, 1 Replies
11-14-2002 03:13 AM
Occasionaly when I open an ".idw" file, the dimensions, callouts etc are not visible, just the part views. If I close the drawing, exit Inventor and start over, everything is then visible. Is this a bug with Inventor, or might it be a problem with the graphics card (3Dlabs GVX1 Pro)?
Thanks for the help.
Phil Quenzi
*G, Ed
Message 2 of 2 (52 Views)

Re: Disappearing dimensions

11-14-2002 04:03 AM in reply to: pquenzi
I have had the same problem. I have an Elsa Gloria
video card. The problem goes away if I close and re-open Inventor.


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
Occasionaly
when I open an ".idw" file, the dimensions, callouts etc are not visible, just
the part views. If I close the drawing, exit Inventor and start over,
everything is then visible. Is this a bug with Inventor, or might it be a
problem with the graphics card (3Dlabs GVX1 Pro)?
Thanks for the help.

Phil Quenzi
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.