The green balls that should appear when hovering over a constrianed point as stopped appearing. Is there toggle or someother way to "turn" these back on?
What version of Inventor?
Are you in an active sketch?
Attach the ipt file here.
You might also indicate the exact url step where you are in the tutorial.
As JDMather suggested, this is likely due to the Constraint Persistence setting. See Paul Munford's article on this subject at this link:
I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.