Inventor General Discussion

Inventor General Discussion

Reply
Active Member
harris.1782
Posts: 6
Registered: ‎07-09-2012
Message 1 of 2 (152 Views)
Accepted Solution

Dimensions causing unwanted angles

152 Views, 1 Replies
07-09-2012 07:26 AM

The issue I have with Inventor 2010 is when i dimension a rectangle to be 44 in wide and 79 in height it becomes a slated rectangle. This event occurs on the work version of Inventor 2010. I have an educational version of Inventor 2010 at home and when I tried this same dimension rectangle at home it didn't have this issue. Is there a setting I need to turn off to fix this> Please help and thank you :smileyhappy:

Hi harris.1782,

 

You've likely toggled off your Constraint Inference and/or Constraint Persistence buttons.

 

See this link:

http://forums.autodesk.com/t5/Autodesk-Inventor/Issue-with-2010-Inventor/td-p/3531308

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com


*Expert Elite*
Curtis_Waguespack
Posts: 2,930
Registered: ‎03-08-2006
Message 2 of 2 (126 Views)

Re: Dimensions causing unwanted angles

07-09-2012 09:22 AM in reply to: harris.1782

Hi harris.1782,

 

You've likely toggled off your Constraint Inference and/or Constraint Persistence buttons.

 

See this link:

http://forums.autodesk.com/t5/Autodesk-Inventor/Issue-with-2010-Inventor/td-p/3531308

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com




  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.