Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
tommy-z
Posts: 35
Registered: ‎09-08-2004
Message 31 of 31 (91 Views)

Re: Dimension in Sketch, driving me bonkers

01-15-2013 02:16 PM in reply to: Curtis_Waguespack

All forgiven, Curtis.

 

I was less than cordial myself when I posted here, but -believe it or not - I did actually hope that there could be a reasonably logical answer, or a trick or hack which might have been applied.

 

Or, at least the relief that someone more experienced than myself could, offer an explain to this apparently weird behavior.

 

But, I shall try in the future to behave myself, and also to address my frustration towards the proper forum and/or personnel

 

Thanks anyway for your time.

 

Have a nice day 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.