This is probably related to the issue I brought up back in the thread
titled
Dimension Relationships in IDW SketchMode
IDW Sketches seem to only keep track of the d#'s until you exit the
sketch. If you come back and try to relate a dim to another one, it
won't do it as I showed in a AVI,.
--
Kent Keller
http://www.KWiKMcad.com
Autodesk Discussion Group Facilitator
"tahdesign" wrote in message
news:6991852.1091813353582.JavaMail.jive@jiveforum2.autodesk.com...
> How did this happen?
> If they were TRUELY the same d dimenion then their values would have
to match.
> Not only in that skecth but for all sketches in the whole part.
> Are these tied to any type of custom paramenter?