I would like to dimension the arc length of a radius in sketch mode and i was wondering if this is possible. I am using Inventor simulation 2010.
Solved! Go to Solution.
Solved by JDMather. Go to Solution.
Solved by PaulMunford. Go to Solution.
Techniques for controlling arc length via parameters have been discussed here in the past - if you can't find the solution post back and I'll see if I still have an old file example.
I put together a post on this that you might find usefull.
I'd CERTAINLY LIKE TO SEE HOW TO DIMENION ARCH LENGTHS IN THE SKETCHES. I've BEEN LOOKING FOR A AHILE AND CANNOT SEEM TO FIND A HOW TO OR FIGURE IT OUT AS OF YET.
-M
http://help.autodesk.com/view/INVNTOR/2017/ENU/?contextId=REDIRECT_ID_SKETCHGENDIM
edit: wrong link above, see this link:
https://forums.autodesk.com/t5/inventor-forum/how-to-dimension-an-arc-length/m-p/5706016#M552950
p.s. it's typically considered poor form to type in ALL CAPS
I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com