Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Is there an easy way to get the Flat pattern area into the parts list through one of the parameters. Do I have to create a parameter and calculate that using the Bend allownance or is it straight forward.
- The Area shown in the iProperties-Physical-General Properties. Is this area the total area on both sides of the sheet metal part. Is dividing this area by 1/2 gives you the Flat pattern area taking the Bend allowance into consideration ???
Is there an easy way to get the Flat pattern
area into the parts list through one of the parameters. Do I have to create a
parameter and calculate that using the Bend allownance or is it straight
forward.
The Area shown in the
iProperties-Physical-General Properties. Is this area the total area on both
sides of the sheet metal part. Is dividing this area by 1/2 gives you the Flat
pattern area taking the Bend allowance into consideration ???
The area displayed there is the total surface
area of the sheet metal part in its folded state. If the flat pattern is a
simple rectangle, the area displayed is the sum of the areas of all six
faces. If the part is much larger than the thickness of the sheetmetal,
dividing by 2 would produce a reasonable approximation of the flat pattern
area.
