Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
ashley.walker
Posts: 36
Registered: ‎10-10-2011
Message 1 of 3 (353 Views)
Accepted Solution

Detailed Drawings and Level Of Detail

353 Views, 2 Replies
12-02-2012 06:29 PM

Hello everyone,

 

I have a model of a Rack that I have configures with iAssembly (2 configurations with different amounts of equipment on them). I have setup 2 level of details to reflect this.

 

1.PNG2.PNG

 

But when I go to the 2D drawings I cannot select either of these Level of Details in the Drawings.

 

3.PNG4.PNG

 

Is there a way to show these level of details? Or should I do this another way?

 

Thank you in advance.

Employee
jozef.dubaj
Posts: 41
Registered: ‎11-22-2011
Message 2 of 3 (338 Views)

Re: Detailed Drawings and Level Of Detail

12-03-2012 02:28 AM in reply to: ashley.walker

Hello Ashley,

 

seems your iassembly file need saveing before use in the drawing. Notice the "LevelofDetail1" in the Drawing View dialog. This is default naming for new LOD created. Seems this was the last time when assembly was saved. Try to save the assembly and place it to new (blank) drawing. Both custom views should be loaded in the list.

Let me know then.

 

Thanks,

Jozef

Active Contributor
ashley.walker
Posts: 36
Registered: ‎10-10-2011
Message 3 of 3 (296 Views)

Thanks, It seemed like it wasn't saving correctly. It is...

12-06-2012 09:50 PM in reply to: jozef.dubaj

Thanks, It seemed like it wasn't saving correctly.

It is now working. :smileyhappy:

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.