Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎12-21-2012
Message 1 of 2 (156 Views)

Design Accelerator - Missing Bolts

156 Views, 1 Replies
12-21-2012 11:08 AM

When I make a bolted connection using the design accelerator, I am usually trying to make multiple connection at once. The holes always are placed in the right place but most of the time all the bolts are missing except for the one placed at the first hole I select. Does anyone have any solutions on getting the remaining bolts to be placed correctly?

*Expert Elite*
Posts: 4,154
Registered: ‎11-13-2006
Message 2 of 2 (125 Views)

Re: Design Accelerator - Missing Bolts

12-24-2012 04:40 PM in reply to: ben_hamm

IV version and SP's would help, if you are using the pattern option, your first hole selection must be the first hole in your pattern.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.