Inventor General Discussion

Inventor General Discussion

Reply
Member
renandrum
Posts: 3
Registered: ‎01-31-2013
Message 1 of 1 (219 Views)

Design accelerator CALCULATED parameters and save to iProperties using iLogic?

219 Views, 0 Replies
02-03-2013 04:53 AM
How to get and save a design accelerator CALCULATED parameters (spur gear) and save to iProperties .Value ( "Custom", "BaseDiameter" ) = RESULT,  using iLogic, after a POSITIVE calculate? Autodesk Inventor 2013.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.