Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
mrattray
Posts: 2,538
Registered: ‎09-13-2011
Message 1 of 2 (199 Views)

Deleting ribbon tabs

199 Views, 1 Replies
01-24-2013 05:44 AM

Does anyone know how to remove tabs from the ribbon? The "Environments" and "Online" tabs are worthless, I'd like to get rid of them and clean up the interface a bit.

Mike (not Matt) Rattray

Distinguished Contributor
eveylynne
Posts: 146
Registered: ‎12-16-2011
Message 2 of 2 (169 Views)

Re: Deleting ribbon tabs

01-24-2013 01:16 PM in reply to: mrattray

If someone answers you, I'd like to know, too.

 

As a side note, if you're not using things in your Environments tab, your pc is still loading them when you start up IV.  There's an Add-Ins manager (You can find it in Tools/Options/Add-Ins,  or Environments/Add-ins) that will let you turn them off.  I barely use any add-ins.  Assembly Bonus Tools, drag & drop Interoperability, iCopy, and iLogic are the only ones I have Automatic/Loaded.  I use the Content Center every so often, but you can load it from the Add-In Manager when you need to use it.  

IV's launch time should improve.  & if not?  The useless menus will at least be bare.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.