Inventor General Discussion

Inventor General Discussion

Reply
New Member
lid2
Posts: 2
Registered: ‎10-13-2012
Message 1 of 3 (198 Views)

Deleting a work point in a part

198 Views, 2 Replies
10-13-2012 11:49 PM

This seems like a bit of a trivial question, but I searched and couldn't find an answer anywhere...

 

I created a work point on a part. How do I delete it? Right clicking on the work point in the model browser doesn't give a Delete menu item. 

 

http://cl.ly/image/1H1P2R2k1X34

*Expert Elite*
harco
Posts: 879
Registered: ‎02-16-2006
Message 2 of 3 (192 Views)

Re: Deleting a work point in a part

10-14-2012 01:40 AM in reply to: lid2

Your image shows constraints so this is an assembly view.

Open the part and delete from there.

New Member
lid2
Posts: 2
Registered: ‎10-13-2012
Message 3 of 3 (187 Views)

Re: Deleting a work point in a part

10-14-2012 02:39 AM in reply to: harco

Thanks! I knew it was probably something obvious...

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.