Inventor General Discussion

Inventor General Discussion

Posts: 4
Registered: ‎02-04-2013
Message 1 of 2 (100 Views)

Delay at selecting lines

100 Views, 1 Replies
02-04-2013 04:56 PM

Hi Guys,

I experience a delay when i want to select a line or curve in a scetch, part or assembly. Normally when you move the cursor over a line it highlites red within a fraction of a second. Now it takes 3 or 4 seconds to be selected.

Can anyone explain whats is the problem, is it a wrong setting or a bug. Never had the problem before. Not in 2012 or in 2013.


Hope you can help me out.


Kind regards,


Rene, The Netherlands

*Expert Elite*
Posts: 4,097
Registered: ‎11-13-2006
Message 2 of 2 (86 Views)

Re: Delay at selecting lines

02-04-2013 09:21 PM in reply to: ribanski

#1 would be to do a system reboot. Almost sounds like something else is using system resources, slowing down your system.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 up2 PDSU / Sim Mech 2015 /
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 335.23
SpacePilot Pro 3.17.7, 6.17., 4.11
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.