Inventor General Discussion

Inventor General Discussion

Reply
Active Member
2013auto
Posts: 9
Registered: ‎12-22-2010
Message 1 of 3 (407 Views)

Cyclic Dependency problem

407 Views, 2 Replies
09-18-2012 07:55 AM

first off, I do not know what this error I keep getting on .idw's of top level assemblies.

I have problems with views not updating after changes were made.

 

This was a layout done in Inventor 2011 and I made changes to the .iam (2013), but I cannot get them to update on the .idw's.

The tree in the .idw's has all my views shown with a "question mark" and I cannot edit anything. I know I could probably delete them and re-insert them, but I have ballons and parts list that I do not want to re-do.

 

I also tried to update between Master & Default view in the Assemblies, no luck.

 

help

 

I attached the Cyclic Dependency error dialog box.

 

thanks for your time

Brian

Employee
Yijiang.Cai
Posts: 359
Registered: ‎05-20-2008
Message 2 of 3 (368 Views)

Re: Cyclic Dependency problem

09-19-2012 01:45 AM in reply to: 2013auto

Hi Brian,

 

Could you attach the dataset or send me @ river-yijiang.cai@autodesk.com for further investigation?

Thanks,
River Cai

Inventor Quality Assurance Team
Autodesk, Inc.
Active Member
2013auto
Posts: 9
Registered: ‎12-22-2010
Message 3 of 3 (351 Views)

Re: Cyclic Dependency problem

09-19-2012 07:09 AM in reply to: Yijiang.Cai

To River Cai,

I ended up fixing my problem.

to re-cap - This is opening a Top Level .idw.

 

It was a problem with resolving fasteners from the Content Center. The system would ask to resolve and then tell that they were not part of the active project.

The particular fasteners would show up fine after that, and every view was fine (I could open from the .idw's).

 

But when I would close the .idw and reopen, the same fasteners needed resolved. I finally did a "Replace from Content Center" and that worked.

 

There must be some minor changes to the fastener name or something . . .

 

Frustrated but fixed.

 

Brian

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!