Inventor General Discussion

Inventor General Discussion

Reply
*Eagland, Ian
Message 1 of 2 (46 Views)

Cutting a sketched line or profile

46 Views, 1 Replies
11-20-2002 12:51 AM
Hi

New to Inventor

We draw a lot of very similar. I can copy the sketch profiles no
problem. However some of these parts are the original profile with bits
cut off. How do I cut lines that are part of a profile into two lines.
Like Autocad Break command.


Regards

Ian
*Singlehurst, Rob
Message 2 of 2 (46 Views)

Re: Cutting a sketched line or profile

11-20-2002 01:15 AM in reply to: *Eagland, Ian
Ian,

I normally will use a construction line that is co-linear with the original
line. You can make these lines equal length and you then have a midpoint
etc.

Cheers,

--Rob Singlehurst

"Ian Eagland" wrote in message
news:3DDBBD83.C05A047@eagland.co.uk...
> Hi
>
> New to Inventor
>
> We draw a lot of very similar. I can copy the sketch profiles no
> problem. However some of these parts are the original profile with bits
> cut off. How do I cut lines that are part of a profile into two lines.
> Like Autocad Break command.
>
>
> Regards
>
> Ian
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.