Inventor General Discussion

Inventor General Discussion

Reply
Member
brankin
Posts: 3
Registered: ‎10-10-2007
Message 1 of 4 (353 Views)
Accepted Solution

Custom title block placement

353 Views, 3 Replies
09-18-2012 12:07 PM

Creating a custom title block in innventor seems to be straight foward however when I save the new title block it offsets from the sheet, up and to the right. How do I get the title block to line up with the sheet

Bill

Thanks Curtis.....that was the problem
*Expert Elite*
Curtis_Waguespack
Posts: 2,942
Registered: ‎03-08-2006
Message 2 of 4 (341 Views)

Re: Custom title block placement

09-18-2012 03:17 PM in reply to: brankin

Hi brankin,

 

Depending on your situation, you can likely fix this by going to the Tools tab > Application Options button > Drawing tab. You'll see the option to control the title block insert point there.

 

Or you might just need to specify your insert point in the sketch:

 

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





*Expert Elite*
mrattray
Posts: 2,507
Registered: ‎09-13-2011
Message 3 of 4 (309 Views)

Re: Custom title block placement

09-19-2012 04:55 AM in reply to: brankin

Do you have a seperate border? I find that having an appropriate border helps with titleblock placement for some odd reason.

Mike (not Matt) Rattray

Member
brankin
Posts: 3
Registered: ‎10-10-2007
Message 4 of 4 (300 Views)

Re: Custom title block placement

09-19-2012 07:44 AM in reply to: Curtis_Waguespack
Thanks Curtis.....that was the problem
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.