Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
jasonraul
Posts: 31
Registered: ‎05-09-2012
Message 1 of 3 (150 Views)
Accepted Solution

custom shapes

150 Views, 2 Replies
06-08-2012 05:01 PM

I made my first custom shape and successfully published it into the Content Centre in my custom section.I have another 10 sizes of the same shape all increasing in size by 5mm.

1. Do i have to create the 10 various sizes individually and publish each 1 to the Content Centre 1 at a time or is there a simpler and quicker way to publish the 10 sizes using the first shape i created?

 

Best Regards

 

Jason

Jason,

You need to generate the iparts from the factory file first before you can publish them.

If you open your factory file up and RC and select all of the iparts in the list in the model tree select generate files.

Then you should be able to publish them all at once.

Active Contributor
jasonraul
Posts: 31
Registered: ‎05-09-2012
Message 2 of 3 (136 Views)

Re: custom shapes

06-08-2012 08:53 PM in reply to: jasonraul

I should have mentioned that these will be used in the Frame Generator

 

Jason

*Expert Elite*
Cadmanto
Posts: 3,356
Registered: ‎12-07-2011
Message 3 of 3 (130 Views)

Re: custom shapes

06-09-2012 04:21 AM in reply to: jasonraul

Jason,

You need to generate the iparts from the factory file first before you can publish them.

If you open your factory file up and RC and select all of the iparts in the list in the model tree select generate files.

Then you should be able to publish them all at once.

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.