Inventor General Discussion

Inventor General Discussion

Reply
Mentor
587 Posts
8 Kudos
Registered: ‎10-22-2007
Post 1 of 4

Custom iproperties within part file issue

171 Views, 3 Replies
09-18-2012 07:45 PM

we have a part file that has 2 custom iproperties in it.

 

Length and Width.

 

If I delete these properties its fine and the properties are removed.

 

However if I then save the file, the properties become available again.

Mentor
587 Posts
8 Kudos
Registered: ‎10-22-2007
Post 2 of 4

Re: Custom iproperties within part file issue

09-18-2012 08:03 PM in reply to: PACDrafting

Ignore this message.

 

I know why its doing this.

 

Thanks

*Expert Elite*
2,546 Posts
889 Kudos
Registered: ‎09-13-2011
Post 3 of 4

Re: Custom iproperties within part file issue

09-19-2012 04:37 AM in reply to: PACDrafting

I know you said to ignore it because you figured it out, but I'm guessing that the properties came from exported parameters and you forgot to uncheck the export option.

Mike (not Matt) Rattray

Mentor
587 Posts
8 Kudos
Registered: ‎10-22-2007
Post 4 of 4

Re: Custom iproperties within part file issue

09-19-2012 04:02 PM in reply to: PACDrafting

That is correct.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post