Inventor General Discussion

Reply
Valued Contributor
floccipier
Posts: 55
Registered: ‎04-11-2011
Message 1 of 2 (88 Views)

Custom Content Center

88 Views, 1 Replies
05-01-2012 10:16 PM

Hi Guys,

I have added a custom shaped C section in Content Center and I got it published but it doesn't ask length. But it works fine with fram generator (changes to length as per the frame skeleton line). I am having problem to understand how I can introduce the length parameter so that I could enter it to desired length whenever required.

 

Please elaborate. any suitable hyperlink will be hightly appreciated.

 

Regards,

Sajid Mahmoopd

*Expert Elite*
cbenner
Posts: 3,258
Registered: ‎04-06-2010
Message 2 of 2 (82 Views)

Re: Custom Content Center

05-02-2012 04:10 AM in reply to: floccipier

When you try to insert this piece form Content Center (not in Frame Generator), do you check "As Custom", or leave it "As Standard"?

 

In this picture, the area where you enter the length is top right.  Choosing Custom will then prompt you to save it as a file somewhere.  Standard will place it in whatever folder you are currently working in, and will automatically name it.

 

ang.JPG

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cbennertipstricks.blogspot.com/


   

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.