Inventor General Discussion

Reply
Valued Contributor
aaron
Posts: 50
Registered: ‎08-26-2010
Message 1 of 1 (88 Views)

Custom Commands

88 Views, 0 Replies
10-23-2012 06:29 AM

I recently put inventor on a different computer and certain settings are not "saving" after I customize them. For example, to lay a center point on a drawing I have always used the command "9." I go in and make that custom command, things work great, but after I reboot the command is gone. I never had this problem on either of my two other computers. Thanks

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!