Community
Howdy all,
Curious if there is any way to change a cropped 'end' to be something other than a flat end? Something maybe more like a shaft end would look, or a zigzag? Something other than just a plain squared off end.
tks!
Break view and move one side off of the sheet.
The CADWhisperer YouTube Channel
Hi JD,
Thanks, but I tried that and the outcome was... not acceptable. In this case it is a shaft I am trying to break or crop, but the part I want to keep in a small diameter next to a large one. Considerable difference. As such if I use break, then it gives me quite large break lines which look odd on the drawing sheet.
Any other thoughts?