Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hi all
I have a Flange with some holes distributed as circular pattern.
I put it in Assembly file & I want to add adaptive gasket on it by using Create Part Command in assembly.
I put a sketch on the red face and create extrude for project geometry of this face by 3 mm.
I found the the outer Diameter is just the only Adaptive.
If i change the number of holes ,it doesn't change automatically on the Gasket(new Created Part).
How can i make the number of holes related between gasket and flange?
see this link also:
http://discussion.autodesk.com/forums/thread.jspa?messageID=5916090?
link above didn't seem to work, try this one:
http://discussion.autodesk.com/forums/thread.jspa?messageID=5916090䖺
Edited by: Bmiller63 on Feb 1, 2010 2:44 PM