Inventor General Discussion

Inventor General Discussion

Reply
Member
Matt-Dimon
Posts: 3
Registered: ‎03-02-2003
Message 1 of 3 (126 Views)

Creating a flexible wire

126 Views, 2 Replies
11-27-2002 05:18 PM
is there any way I can create a piece of wire that will flex into position when placed in a *.iam? The position will change dependent of the *.iam it place into there for some sort of ipart would be good.
Active Member
rasmussen.egon
Posts: 9
Registered: ‎12-31-2002
Message 2 of 3 (126 Views)

Re: Creating a flexible wire

11-27-2002 07:03 PM in reply to: Matt-Dimon
Hi Matt-Dimon

Could you explain a bit more ?.

Egon
*Dotson, Sean
Message 3 of 3 (126 Views)

Re: Creating a flexible wire

11-28-2002 01:33 AM in reply to: Matt-Dimon
You probably want to look at adaptive 3D
sketches.  They are made in the context of the assembly.  iParts are
not adaptive.  See my tutorial on Introduction to 3D Sketches for more
info.


--
Sean Dotson, PE

href="http://www.sdotson.com">http://www.sdotson.com

Check the Inventor
FAQ for most common questions


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
is
there any way I can create a piece of wire that will flex into position when
placed in a *.iam? The position will change dependent of the *.iam it place
into there for some sort of ipart would be good.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.