Inventor General Discussion

Inventor General Discussion

Reply
New Member
inventor444
Posts: 1
Registered: ‎10-06-2012
Message 1 of 2 (124 Views)

Create a sketch with line starting points depending on other sketches

124 Views, 1 Replies
10-06-2012 02:09 AM

Hello

 

I want to draw a line between the two sketches visible on the image below. The line should be in the plane visible. The starting point of the line should be from wherever the top sketch intersects  the plane of the current sketch. The finnish point of the line should be wherever a line of the bottom sketch intersects the current sketch plane.

 

There is no tooltip appearing that would allow me to quickly "attach" the starting line to the correct position. Is there such an aid, and how do i turn it on?2.jpg1.jpg

*Expert Elite*
JDMather
Posts: 26,832
Registered: ‎04-20-2006
Message 2 of 2 (117 Views)

Re: Create a sketch with line starting points depending on other sketches

10-06-2012 05:46 AM in reply to: inventor444

Project Geometry.

 

and

your first two sketches aren't constrained.

http://home.pct.edu/~jmather/SkillsUSA%20University.pdf

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.