Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I'm having quite a problem dimensioning a part I have created. I have two sets of circular patterened holes that are displaced from the center of a large disc. I would like to be able to use the Centered Pattern tool, but I cannot without a center point or hole, which does not exist. Any suggestions about how to create a Centered Pattern in this case? I have attached both the part and a sample drawing for clarification.
Aha! Thanks John! I tried to follow some steps I saw on a different set of instructions on the forum that weren't very clear, and didn't realize I could include the Work Point into my drawing. Perfect! Thanks so much.
