Inventor General Discussion

Inventor General Discussion

Reply
New Member
alfie_smith10
Posts: 1
Registered: ‎11-10-2002
Message 1 of 2 (37 Views)

Crashing Inventor 5.3

37 Views, 1 Replies
11-10-2002 08:28 AM
Every time I try to create a flat pattern from a sheet metal part I get the following illegal operations:

INVENTOR caused an invalid page fault in
module ATIO9XAA.DLL at 0177:69132be6.
Registers:
EAX=06e3000c CS=0177 EIP=69132be6 EFLGS=00010206
EBX=00000000 SS=017f ESP=00d9f650 EBP=05e3749c
ECX=00000000 DS=017f ESI=05e3749c FS=4447
EDX=05e3749c ES=017f EDI=05e37420 GS=0000
Bytes at CS:EIP:
ff 51 60 85 c0 0f 95 c0 c3 90 53 56 8b f1 8b 86
Stack dump:
06e3000c 69131684 05e37420 00000000 691316b3 00d9f6fc 05e37420 05e3749c 00000000 691318b9 00d9f6fc 4b488b88 00000000 00000000 69131a5c 00d9f6fc


INVENTOR caused an invalid page fault in
module KERNEL32.DLL at 0177:bff9db61.
Registers:
EAX=c00309c4 CS=0177 EIP=bff9db61 EFLGS=00010212
EBX=0541fe28 SS=017f ESP=0531ff68 EBP=05320204
ECX=00000000 DS=017f ESI=00000000 FS=653f
EDX=bff76855 ES=017f EDI=bff79198 GS=0000
Bytes at CS:EIP:
53 8b 15 e4 9c fc bf 56 89 4d e4 57 89 4d dc 89
Stack dump:

My graphics card is an ATI 128 xpert.

Does anyone know how to get around this?
*darvinv
Message 2 of 2 (37 Views)

Re: Crashing Inventor 5.3

11-10-2002 09:50 AM in reply to: alfie_smith10
Suggest you goto this link. As far as I know, if a
card/driver combo is not showing a green dot on this page, it is probably not
reliable in inventor! You may get some work out of it, but sooner or later you
hit a wall. Seen that ATI*****.dll in a lot of stack dumps.

 


 

darvin
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.