Inventor General Discussion

Inventor General Discussion

Reply
Contributor
syed.dzulkarnain
Posts: 20
Registered: ‎07-05-2009
Message 1 of 3 (265 Views)

Could not open the DWG template file. Please check the path and try again.

265 Views, 2 Replies
10-10-2012 03:03 AM

Hi everyone,

 

i'm having a problem when everytime i try to do a BIM Exchange from my Inventor 2013, it pop ups

'Could not open the DWG template file. Please check the path and try again' halfway through the process.

anyone have face the same issue before? i'm trying to create .adsk file to integrate with Revit. 

 

anyone can help me with this?:smileyembarrassed:

 

New Member
george.lawson
Posts: 1
Registered: ‎02-02-2014
Message 2 of 3 (88 Views)

Re: Could not open the DWG template file. Please check the path and try again.

02-02-2014 01:08 AM in reply to: syed.dzulkarnain

I have the same problem. I have checked the template file path and can't find a problem.

 

does anyone know how to overcome the issue?

Active Contributor
infopsm
Posts: 34
Registered: ‎07-12-2007
Message 3 of 3 (58 Views)

Re: Could not open the DWG template file. Please check the path and try again.

02-14-2014 04:09 AM in reply to: syed.dzulkarnain

Is possibly you need to re-install Autodesk Trueview or Design Review with Trueview included.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.