Inventor General Discussion

Inventor General Discussion

Reply
Active Member
rptandy
Posts: 20
Registered: ‎09-09-2011
Message 1 of 1 (80 Views)

Controlling Instance Names of iLogic Assemblies

80 Views, 0 Replies
05-15-2012 08:52 AM

When using "Place ilogic component" in an assembly, is there a way to control the name of the ilogic assembly instance that is created? Right now, Inventor is just adding -01, -02, etc to the end of the original ilogic assembly name. I would like to be able to enter the name I want and possibly where the file should be saved without having to insert the assembly, then use "save and replace".

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.